Do not change the specification of this appliance. • Obey the maximum load volume of 9 kg (refer to the • “Programme chart” chapter). The operating water pressure (minimum and maximum) must be • between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa). www.zanussi.com...
• The appliance must be earthed. • Before you connect the appliance to new • Always use a correctly installed shockproof pipes or pipes not used for a long time, let socket. the water flow until it is clean. www.zanussi.com...
If possible install the appliance in one of the susceptible to vibration. corners of the room, where the floor is more To help prevent vibration we recommend you stable. place a waterproof wood panel, at least 15 mm thick under the appliance, secured to at least 2 www.zanussi.com...
: the programme is completed. B) The child lock indicator: Finish In • The indicator comes on when you activate this device. C) The extra rinse indicator: • The indicator comes on when you activate this option. D) The Finish In touchpad. www.zanussi.com...
A short cycle for synthetics and delicate items with light soil level or for 30 °C items to freshen up. 3 kg 800 rpm for model ZWF 91283W; 800 rpm for model ZWF 91483W Cottons White cotton and coloured cotton. Normal soil and light soil. 90 °C - Cold 9 kg 1200 rpm for model ZWF 91283W;...
Standard 40 °C 0,62 / 52 cotton 1) At the end of spin phase. 2) For model ZWF 91283W. 3) For model ZWF 91483W. Off Mode (W) Left On Mode (W) 0,48 0,48 The information given in the chart above are in compliance with the EU Commission regulation 1015/2010 implementing directive 2009/125/EC.
To deactivate/activate the acoustic signals, • To activate/deactivate this option, touch touch the buttons at the same time the buttons at the same time until for 4 seconds. the indicator comes on/goes off. See in "Settings" how to activate this option. www.zanussi.com...
Do not exceed the seal and the MAX level. door. There is a risk of Flap for powder or liquid detergent. water leakage or damage to Liquid or powder detergent the laundry. The default position of the flap is A (powder detergent). www.zanussi.com...
• The door is locked. The animation quickly shows each washing • The appliance starts the countdown. programme and the default temperature and • When the countdown is completed, the spin settings. programme starts automatically. The display shows the word On. www.zanussi.com...
• Alternatively, touch the button CAUTION! change the spin speed and then touch If the temperature and level of the the button . The appliance drains the water in the drum are too high, you cannot open the door. www.zanussi.com...
For some stains, water and detergent is not • If necessary, use a stain remover when you sufficient. set a programme with a low temperature. We recommend that you remove these stains before you put the items in the appliance. www.zanussi.com...
With the low temperature programmes it is possible that some detergent stays in the drum. Make regularly a maintenance wash. To do this: • Remove the laundry from the drum. • Set the cotton programme with the highest temperature with a small quantity of detergent. www.zanussi.com...
Service Centre. off and switch on again. WARNING! With some problems, the acoustic signals Deactivate the appliance before you operate and the display shows an alarm do the checks. code: • - The appliance does not fill with water properly. www.zanussi.com...
Page 16
Make sure the levelling of the appliance is correct. Refer to 'Installa- The appliance makes an un- tion instruction'. usual noise. • Make sure that the packaging and/or the transit bolts are removed. Refer to 'Installation instruction'. • Add more laundry in the drum. The load may be too small. www.zanussi.com...
Water supply pressure Minimum 0,5 bar (0,05 MPa) Maximum 8 bar (0,8 MPa) Cold water Water supply Maximum Load Cotton 9 kg Energy Efficiency Class A+++ www.zanussi.com...
Spin Speed Maximum 1200 rpm (ZWF 91283W) 1400 rpm (ZWF 91483W) 1) Connect the water inlet hose to a water tap with a 3/4'' thread. ENVIRONMENTAL CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it.