MALTEC ProMica2500W Eco Instruction Manual page 7

Assembly
 Insert the wheels into the bottom part of the supporting feet, and to be sure it is tight
enough.
 Put the appliance with upside down, fix the to the appliance with screw
INSTRUCTIONS FOR USE AND OPERATION OF THE REMOTE
CONTROL
 Connect the appliance to the power outlet.
 Put the switch in position I
 Press the On/Off button
 Press the Heat Setting button to set the desired power:
◦ Position 1: Minimum power, 1500W
◦ Position 2: Maximum power 2500W
 Set the temperature. Press the Temp Setting button to increase the temperature by
1°C each time:
◦ Position 1 (1000W): You can select from 18 to 24°C
◦ Position 2 (2000W): You can select from 25 to 30°C
 Set timer. Each time you press the Timer button, the timer will increase by 0.5 hours
up to a maximum of 12 hours.
Overheat safety device
 Your heater is fitted with a safety device to switches off the heater in the event of
overheating. If the safety device operated, please turn the heater off, unplug the
appliance and let it completely cool, inspect for blockage of air inlet or outlet,
attempting to restart the heater then after.
 If the heater fails to operate or the safety device switches the heater off again,
return heater to your nearest service center for examination or repair.
7/12