Joy-it DSO-LCR500 Manual page 28

DS18B20: Measuring DS18B20 temperature sensors -
Connect your sensor to the test sockets 1, 2 and 3. The
measurement starts automatically.
DHT11: Measurement of DHT11 temperature sensors -
Connect pins 1, 2 and 4 of your DHT11 sensor to test
sockets 1, 2 and 3 of your instrument. The measurement
starts automatically.
NOTICE: Due to the complexity and variety of DS18B20 and DHT11
sensors, it is possible that not all sensors can be detected correctly.
Our device is designed and tested to detect and measure original
sensors. If a sensor cannot be detected, this could be due to a number
of factors. In particular, we would like to point out that there are
counterfeit sensors circulating on the market that differ from the
originals in terms of their design and functionality. Such sensors may
not be correctly detected or measured by our device.
IR Decoder: Point your infrared remote control at the IR
marker and press a button on the remote control. The
device automatically starts decoding the signal and,
after successful decoding, displays the data and user
codes, as well as the infrared waveform.
10