Installation And Connection - Hitachi HMR-M2002 Instruction Manual

1 Your microwave oven
1.3 Installing the turntable
• Never place the glass tray upside down. The
glass tray should never be restricted.
• Both glass tray and turntable support must
always be used during cooking.
• All food and containers of food must always
place on the glass tray for cooking.
• If glass tray or turntable support crack or
break,contact your nearest authorized service
center.

2 Installation and connection

2.1 Installation
1. Make sure that all the packing materials
are removed from the inside of the door.
WARNING: Check the oven for
any damage, such as
misaligned or bent door,
damaged door seals and
sealing surface, broken or loose
door hinges and latches and
dents inside the cavity or on the
door. If there is any damage, do
not operate the oven and
contact qualified service
personnel.
2. This microwave oven must be placed on a
flat, stable surface to hold its weight and
the heaviest food likely to be cooked in
the oven.
3. Do not place the oven where heat,
moisture, or high humidity are generated,
or near combustible materials.
4. For correct operation, the oven must have
sufficient airflow. Allow 20 cm of space
above the oven, 10 cm at back and 5 cm
at both sides. Do not cover or block any
openings on the appliance. Do not
remove feet.
ENGLISH 10
Hub (underside)
Glass tray
Turntable ring assembly
5. Do not operate the oven without glass
tray, roller support, and shaft in their
proper positions.
6. Make sure that the power supply cord is
undamaged and does not run under the
oven or over any hot or sharp surface.
7. The socket must be readily accessible so
that it can be easily unplugged in an
emergency.
8. Do not use the oven outdoors.
2.2 Radio interference
Operation of the microwave oven can cause
interference to your radio, TV, or similar
equipment. When there is interference, it
may be reduced or eliminated by taking the
following measures:
1. Clean door and sealing surface of the
oven.
2. Reorient the receiving antenna of radio or
television.
3. Relocate the microwave oven with
respect to the receiver.
4. Move the microwave oven away from the
receiver.
5. Plug the microwave oven into a different
outlet so that microwave oven and
receiver are on different branch circuits.