Installing The Turntable; Installation And Connection - Hitachi HMR-DG2312 Instruction Manual

1 Your microwave oven

1.3 Installing the turntable

• Never place the glass tray upside down. The
glass tray should never be restricted.
• Both glass tray and turntable support must
always be used during cooking.
• All food and containers of food must always
place on the glass tray for cooking.
• If glass tray or turntable support crack or
break, contact your nearest authorized
service center.

2 Installation and connection

2.1 Installation and
connection
• Remove all packing material and
accessories. Examine the oven for any
damage such as dents or broken door. Do
not install if oven is damaged.
• Remove any protective film found on the
microwave oven cabinet surface.
• Do not remove the light brown Mica cover
that is attached to the oven cavity to protect
the magnetron.
• Select a level surface that provide enough
open space for the intake and/or outlet
vents.
30 cm
20 cm
20 cm
20 cm
min.85 cm
• Minimum installation height is 85 cm.
• The rear surface of appliance shall be
placed against a wall. Leave a minimum
clearance of 30 cm above the oven, a
minimum clearance of 20 cm is required
between the oven and any adjacent walls.
ENGLISH 10
Hub (underside)
Glass tray
Turntable shaft
• Do not remove the legs from the bottom of
the oven.
• Blocking the intake and / or outlet openings
can damage the oven.
• Place the oven as far away from radios and
TV as possible. Operation of microwave
oven may cause interference to your radio
or TV reception. 2. Plug your oven into a
standard household outlet. Be sure the
voltage and the frequency is the same as
the voltage and the frequency on the rating
label.
WARNING: Do not install oven
over a range cooktop or other
heatproducing appliance. If
installed near or over a heat
source, the oven could be
damaged and the warranty
would be void.
The accessible surface may be
hot during operation.
Turntable support
Döner tabla desteği