Table of Contents
Advertisement
Countertop Installation
Remove all packing material and accessories.
Examine the oven for any damage such as
dents or broken door. Do not install if oven is
damaged.
INSTALLATION
Remove all the packaging from the oven and check for any damage, for example, deformation or breakage of the
door, gaps around the door or dents on the cabinet or door.
Should any damage be found, do not use the microwave oven but contact a fully qualified service agent. The
servicemen will check the damage and repair the oven if necessary.
PLACE OF INSTALLATION
Place the microwave oven on a level and
sturdy surface
If the surface is not level the door may not
open automatically
Allow an ample space between the microwave
oven and wall
The wall may be soiled with the excess steam
mist
from the air outlets
place the microwave oven
near a curtain. Allow a space of 7cm or more
from the top surface, 3cm either side, and a
minimum of 5cm at the rear for ventilation
during cooking of the microwave oven.
Air inlets and air outlets should be kept free
at all times to allow for ventilation.
at the rear. Do not
GB
Cabinet: Remove any protective film found
on the microwave oven cabinet surface.
Do not remove the light brown Mica cover
that is attached to the oven cavity to
protect the magnetron.
Do not place the microwave oven near a gas
appliance which produces heat or steam or
near the sink where the water may splash on it
Heat, steam or water may cause parts failure and
damage
Place the microwave oven more than three
metres away from radios, TVs and antenna
lines
The microwave oven may cause
interference
or distort the picture
Do not place the power cored across the oven
or against a hot surface.
9
noise
Advertisement
Table of Contents
