Table of Contents
Advertisement
Preparation
Planning
Survey your area to see if any of the conditions below apply to your installation.
Depending on your requirements, additional materials may be required.
THIS DOOR OPENER IS COMPATIBLE WITH:
•
Doors that use a torsion bar and springs. The torsion bar must be 1" (2.5 cm)
diameter. NOT compatible with reverse wound drums.
•
4-6" (10-15 cm) drums, not to be used on tapered drums over 6" (15 cm).
•
3 to 3.9 inch (7.6cm to 9.9cm) drums may be used on doors up to 430lbs.
(195.4Kgs)
•
High lift (up to 54" (137.2 cm) high) and standard lift sectional doors up to 14 ft.
(4.3 m) high.
•
Doors up to 18 ft. (5.5 m) wide.
Review or inspect proposed installation
area. The door opener can be installed on
the left or right side of door. Select the side
that meets the requirements listed below.
a.
Must have minimum of 2.5" (6.4 cm)
between the wall and the center of the
torsion bar.
b.
Must have minimum of 3" (7.6 cm)
between the ceiling and the center of
torsion bar.
c.
Must have minimum of 8.5" (21.6 cm)
between the side wall (or obstruction)
and the end of torsion bar.
d.
The torsion bar must extend at least
1.5" (3.81 cm) past the bearing.
This may vary depending on your
installation requirements.
e.
An electric outlet is required within
6 ft. (1.83 m) of the installation area.
If outlet does not exist, contact a
qualified electrician.
f.
Depending upon building
construction, extension brackets or
wood blocks may be needed to install
safety reversing sensors and cable
tension monitor.
g.
Alternate floor mounting of the
safety reversing sensors will require
hardware (not provided).
h.
Check the seal on the bottom of the
door. Any gap between the floor and
the bottom of the door must not
exceed 1/4 inch (6 mm). Otherwise,
the safety reversal system may not
work properly.
c
8.5"
(21.6 cm)
d
Torsion bar
Wall or
obstruction
e
Automatic
door lock
Safety
reversing
sensor
3
NOTE: Inspect the torsion bar while the
door is raised and lowered. It is important
that there is no noticeable movement up
and down or left and right. If the movement
is not corrected, the life of the garage door
opener will be greatly reduced.
b
3"
(7.6 cm)
a
2.5"
(6.4 cm)
Door spring
g
f
h
Torsion
bar
myQ Remote
LED Light
Advertisement
Table of Contents
