Specifying A World Time City; Swapping Your Home Time And World Time; Alarm; Configuring Alarm Settings - Casio 5714 Operation Manual

Specifying a World Time City

Use the procedure in this section to select a
World Time city. If you are in an area that
observes summer time, you can also
configure a summer time setting.
1.
Enter the World Time Mode.
Navigating Between Modes
l
2.
Press (D) to display the city code of the
currently selected city.
Holding down (D) scrolls through
●
settings at high speed.
For information about city codes, see
●
the information below.
City Table
l
City code
3.
If you want to configure the summer time
setting, hold down (A) for at least three
seconds.
[DST] is displayed along with summer
time.
Each time you hold down (A) for at least
●
three seconds, the setting toggles
between standard time and summer
time.
Note
The summer time setting you configure
●
is applied to the currently selected city
only. It does not affect other cities.
Watch Operation Guide 5714
Swapping Your Home Time
and World Time
In the World Time mode, press (A) and (B) at
the same time to swap your Home City time
with your World Time.
Before swapping
Home Time
World Time
The watch will beep when the alarm time is
reached. You can configure up to four
standard daily alarms, and one daily alarm
with snooze. The hourly time signal causes the
watch to beep every hour on the hour.
After swapping
Snooze causes the alarm to sound up to
●
World Time
seven times, at five-minute intervals.
Home Time

Configuring Alarm Settings

1.
Enter the Alarm Mode.
l
2.
Press (D) to scroll through alarms ([AL1]
to [AL4], [SNZ]) until the one you want to
configure is displayed.
3.
Hold down (A) for at least three seconds.
Release the button when the hour digits
start to flash.
●

Alarm

Navigating Between Modes
Alarm number
Alarm time
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Alarm hour
9