Using The Fingerprint Sensor - Toshiba Tecra M9 User Manual

2. Position a new cap on the peg and press it into place.
The peg is square, so be careful to align the cap's square hole with the
peg.

Using the Fingerprint Sensor

This product has a fingerprint utility installed for the purpose of enrolling
and recognizing fingerprints. By enrolling the ID and password onto the
fingerprint authentication feature, it is no longer necessary to input the
password from the keyboard. Fingerprint feature enables you to:
■
Logon to Windows and access a security enabled homepage through
Internet Explorer.
■
Files and folders can be encrypted/decrypted and third party access to
them prevented.
■
Disable the password-protected screen-saver when returning from a
power-saving mode such as Sleep Mode.
■
Authentication of the User Password (and, if applicable, the HDD(Hard
Disk Drive) Password) when booting up the computer (Power-on
Security).
■
Single Sign-on facility
How to Swipe your Finger
Using the following steps when swiping fingers for fingerprint registration or
authentication will help to minimize authentication failures:
Align the first joint of the finger at the center of the sensor, then lightly touch
the sensor and swipe finger horizontally towards you until the sensor
surface becomes visible. In performing this process, you should also take
care to ensure that the center of your fingerprint is on the sensor.
The following illustrations show the recommended way to swipe your finger
over the fingerprint sensor.
User's Manual
Sensor
Swipe the finger
Sensor
M9
4-3