Toshiba Tecra M9 User Manual page 65

Installing a memory module (Slot B)
To install a memory module, follow the steps as detailed below:
1. Set the computer to Boot Mode and turn its power off - make sure the
Power indicator is off (refer to the
Chapter 1,
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Turn the computer upside down and remove the battery pack (refer to
the
Up
4. Loosen the screw securing the memory module cover in place - please
note that this screw is attached to the cover in order to prevent it from
being lost.
Use a point size 0 Phillips screwdriver.
5. Slide your fingernail or a thin object under the cover and lift it off.
6. Align the notch of the memory module with that of the memory slot and
gently insert the module into the slot at about a 45 degree angle before
holding it down until the latches on either side snap into place.
User's Manual
Getting Started, if required).
Replacing the battery pack
Modes, if required).
Memory module cover
Screw
Removing the memory module cover
Slot B
Seating the memory module
Turning off the power
section in Chapter 6,
M9
section in
Power and Power-
3-23