DeLonghi ECAM37X.85 Manual page 25

PROBLEM
The infuser cannot be extracted
At the end of descaling, the appliance
requests a third rinse
Milk does not flow from the milk
spout (E5)
The milk contains large bubbles and
squirts out of the milk spout (E5) or
there is little froth
The machine emits noises or small
puffs of steam while not in use
POSSIBLE CAUSE
The appliance has not been turned off
correctly
During the two rinse cycles, the water
tank (A17) has not been filled to the
MAX level
The milk container (E) lid (E2) is dirty
The milk is not cold enough or is not
semi-skimmed or skimmed.
The froth adjustment dial (E1) is incor-
rectly adjusted.
The milk container lid (E2) or froth ad-
justment dial (E1) are dirty
The hot water connection nozzle (A8)
is dirty
The machine is ready for use, or has re-
cently been turned off, and condensate
is dripping into the hot vaporiser
25
REMEDY
Turn the appliance off by pressing the
ton (A15) (see section "5. Turning the appliance
off").
Follow the instructions displayed by the appli-
ance, but first empty the drip tray (A15) to avoid
the water overflowing.
Clean the milk container lid as described in
section "12.10 Cleaning the milk container".
Use skimmed or semi-skimmed milk at refrig-
erator temperature (about 5° C). If the result is
not as expected, try a different brand of milk.
Adjust following the instructions in section "9.
Making cappuccinos and milk-based coffees".
Clean the milk container lid and control knob
as described in the section "12.10 Cleaning the
milk container".
Clean the connection nozzle as described in
section "12.11 Cleaning the hot water nozzle".
This is part of normal operation. To limit the
phenomenon, empty the drip tray.
but-