Table of Contents
Advertisement
When the appliance operates at the
preset temperature, the door locks.
When the pyrolytic cycle starts,
the lamp does not work and the
cooling fan works at a higher
speed.
Do not open the door during the heating
up time. If you open the door, you will
cancel the pyrolytic cleaning cycle.
To stop the pyrolytic cleaning cycle, touch
.
Do not use the appliance until the door
lock symbol is off.
12.3 Shelf supports
Removing the shelf supports
1
Installing the shelf supports
Install the shelf supports in the opposite
sequence.
Valid for telescopic runners:
The retaining pins on the tele-
scopic runners must point to the
front.
2
12.2 Cleaning reminder
It shows you when to do the cleaning.
The display shows a message after the
appliance operates for some hours.
Activate and deactivate the Cleaning re-
minder function in the menu Cleaning .
The Cleaning reminder function deacti-
vates when you set the appliance to the
factory settings.
You can remove the shelf supports to
clean the side walls.
1.
Pull the front of the shelf support
away from the side wall.
2.
Pull the rear end of the shelf support
away from the side wall and remove
it.
12.4 Lamp
WARNING!
There is a risk of an electrical
shock.
The lamp and the lamp glass cov-
er can be hot.
Before you change the lamp:
• Deactivate the appliance.
• Remove the fuses from the fuse box or
deactivate the circuit breaker.
ENGLISH
35
Advertisement
Table of Contents
