Drain Requirements; Space Requirements; Safety Precautions - Labconco SteamScrubber 45780 Series User Manual

Chapter 2: Prerequisites

Drain Requirements

The drain hose, .57" (1.45 cm) ID is installed during manufacture. The hose
provides a flexible coupling to the building drain piping and can be secured with a
spring or band hose clamp. (A band hose clamp is provided with the washer.)
Tubing or pipe, 5/8" (1.6 cm) ID or larger, should be provided for the building
drain. The use of an air gap is strongly recommended to prevent siphoning of
wastewater into the washer.
Do not reduce the size of the drain plumbing.
Glassware Washers that have been converted to Mobile models drain into a sink
through a hose assembly that attaches to the faucet.

Space Requirements

If your Glassware Washer is an Undercounter model, you must ensure the
undercounter opening is the proper size to accommodate the washer. The
dimensions for the Undercounter washer are shown in Appendix B.

Safety Precautions

When lifting this product, use at least two (2) persons and always use safe lifting
practices.
Do NOT use a detachable power cord that is not adequately rated for this product.
Always disconnect power before beginning service operations.
Do not damage internal wiring or other components while service panels are
removed. If internal wiring or components are damaged, do not restore power,
contact Labconco's Product Service Department immediately.
Wear all required Personnel Protective Equipment (PPE) during service
operations. At a minimum, this includes: eye protection, breathing protection,
skin protection. Do not wear loose fitting clothes that can catch on internal
surfaces.
After service, verify safe state of use before using the product. Contact
Labconco's Product Service Department for questions on determining safe
state of this product.
Verify protective earth ground continuity before using equipment.
No special ventilation requirements.
Product Service 1-800-522-7658 5