Labconco SteamScrubber 45780 Series User Manual page 26

Chapter 3: Getting Started
8. Press the ▼ button and the arrow on the display will point to DETERGENT
CUP.
9. Press either the ► or ◄ button to energize the detergent cup. Within about 1
minute the detergent cup door should be heard to open.
10. Press the ▼ button and the arrow on the display will point to HEATER.
11. Press either the ► or ◄ button and the heater will be energized.
12. Press the ▼ button and the arrow on the display will point to DRAIN / COOL.
13. Press either the ► or ◄ button and the drain will be energized. Allow all
water to be drained from the washer. The sound of the pump will change
when all water is drained. This will take about 1-1/2 to 2 minutes. If the Cool
Water Drain Kit accessory has been installed, cool water will mix with hot
water draining from the washer.
14. Press the ▼ button and the arrow on the display will point to DRY BLOWER.
15. Press either the ► or ◄ button and the dry cycle blower will be energized.
16. The ▼ arrow in the lower right side of the display indicates that more
selections may be made. Press the ▼ button to select the next function to test.
The arrow on the display will point to LIQ DETERG PUMP.
17. Press the ► or ◄ button and if the liquid detergent accessory has been
installed and if it was activated in the Set Up procedure, the detergent pump
will operate.
18. Press the ▼ button and the arrow on the display will point to LIGHT.
19. Press either the ► or ◄ button and if the washer is equipped with a window
in the door, the light inside the washer will illuminate.
20. Press the ▼ button and the arrow on the display will point to COOL FAN.
21. Press either the ► or ◄ button and the small fan inside the kick panel will
operate.
22. This completes the check of most of the washer functions. Unlatch the door
to exit from the Diagnostics mode.
23. To verify the proper operation of the overfill switch, repeat steps 1 & 2 above.
Press either ► or ◄ button and allow tap water to enter the tank until the
water flow turns off.
24. Press and hold the RUN button. Water will enter the washer and should turn
off before it overflows.
25. Press the ▼ arrow until DRAIN/COOL is highlighted.
26. Press ► or ◄ button to drain water from the washer.
27. Unlatch the door to exit from the Diagnostics mode.
22 Product Service 1-800-522-7658