Table 1. Screw list (continued)
Component
Antenna modules
System board
Base panel
Display panel
Media-card reader
Back cover
Removing the back cover
Prerequisites
1. Follow the procedure in
CAUTION:
When servicing the computer, place it on an elevated, clean and flat surface. Place the display
flat on the surface with the stand hanging over the edge. It is recommended to remove the stand to avoid
accidental damage to the computer display during servicing.
About this task
The following image indicates the location of the back cover and provides a visual representation of the removal procedure.
Secured to
Base panel
Display-assembly base
Display-assembly base
Display-assembly base
Display-assembly base
Before working inside your
Screw type
Quantity
M2x2.5
2
M3 0.5x5
5
M3x5
19
M3 0.5x5
11
M2x3
1
computer.
Removing and installing components
Screw image
11