Table of Contents
Advertisement
Fitting
When fitting, make sure that the lettering "right above" is upside
down at the bottom left on both panels.
Insert the lower panel diagonally towards the back (fig. A).
1.
Insert the centre panel (fig. B).
2.
$
Stick the retaining clips onto the right and left-hand side of
3.
the panel, aligning them so that the carriers are over the
screw holes, and then screw in place (fig. C).
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Problem
The appliance does not work.
The text "Set clock" appears in the
display. The time is not the current time.
The oven does not heat up or the type of
heating selected cannot be set.
The oven does not heat up. The text
"Demo" is displayed.
A reference to the cleaning system
appears when the
button is pressed.
p
"Automatic switch-off" appears in the
display.
Error messages with E
If an error message with E is shown in the display, press the
button. This cancels the error message. You may then have
0
Error message
E011
%
Possible cause
Defective fuse
Power cut
Type of heating not recognised
The oven is in demo mode.
The appliance is not equipped
with the cleaning system.
Automatic switch-off has been
activated. The oven switches off.
Possible cause
A button has been pressed for too
long.
&
Insert the uppermost panel diagonally towards the back. The
4.
smooth surface must face outwards.
Put the cover back in place and screw it on.
5.
Attach the oven door.
6.
Do not use the oven again until the panels have been
correctly fitted.
Malfunction table
If a dish does not turn out exactly as you wanted, refer to the
Tested for you in our cooking studio section, where you will
find plenty of cooking tips and tricks.
ã=
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Note/remedy
Look in the fuse box and check that the circuit
breaker is in working order.
Turn the rotary selector to set the current time then
press the
0
button.
Make the settings again.
Switch off the circuit breaker in the fuse box and
then switch back on after approx. 20 seconds. In
the next 2 minutes hold the
four seconds until the text "Demo" disappears.
The button only works if you retrofit the self-
cleaning ceiling and the side components and
subsequently activate the cleaning system in the
basic settings. See the Cleaning system section
and the Basic settings section.
Press any button. The text disappears. You can
make settings again.
to reset the time. If the error is shown again, call the after-sales
service.
You can take remedial action yourself if the following error
message is displayed.
Note/remedy
Press all buttons individually. Check that the
buttons are clean. If the error message remains,
please contact the after-sales service.
D
button down for
19
Advertisement
Table of Contents
