Cleaning The Control Panel And Housing; Cleaning The Airflow Slots; Troubleshooting - Zanussi ZDC37202W User Manual

CLEANING THE CONTROL PANEL AND
HOUSING
Use a standard neutral soap detergent to clean the
control panel and housing.
Use a moist cloth to clean. Dry the cleaned
surfaces with a soft cloth.
CAUTION! Do not use furniture
cleaning agents or cleaning agents
which can cause corrosion to clean
the appliance.

TROUBLESHOOTING

You cannot activate the appliance.
The programme does not start.
The appliance door does not close.
The appliance stops during operation.
Drying cycle lasts an unusually long time.
Drying cycle ends shortly after programme starts.
1) After maximum 5 hours, the programme ends automatically
If the drying results are not satisfactory
• The set programme was incorrect.
• The filter is clogged.
• The condenser is clogged.
• There was too much laundry in the appliance.
Problem

CLEANING THE AIRFLOW SLOTS

Use a vacuum cleaner to remove the fluff from the
airflow slots.
Make sure that the mains plug is connected to
the mains socket.
Check fuse in fuse box (domestic installation).
Press Start/Pause.
Make sure that the appliance door is closed.
Make sure that the installation of the filter is cor-
rect.
Make sure that the laundry does not catch be-
tween the appliance door and the rubber seal.
Make sure that the water container is empty.
Press Start/Pause to start the programme again.
Make sure that the weight of the laundry is appli-
1)
cable to the duration of the programme.
Make sure that the filter is clean.
The laundry is too wet. Spin the laundry in the
washing machine again.
Make sure that the room temperature is not too
warm.
Set the Time Drying or the Extra Dry programme.
• The drum is dirty.
• Incorrect setting of the conductivity sensor.
• The airflow slots are clogged.
Possible solution
11