Cleaning The Drum; Cleaning The Airflow Slots; Cleaning The Control Panel And Housing - Zanussi TC180W User Manual

To clean the condenser:
1
1 Open the door.
2 Open the coarse filter upwards. Remove the fluff filter and close the coarse filter again.
3 Grasp the recesses at the top of the condenser with your fingers and use your thumbs to press against
the door.
4 The condenser will come free, allowing you to lift it outwards/upwards. Be careful not to damage the
sensitive aluminium section
5 Turn it upside down and clean it on both sides, using a vacuum cleaner.
6 Remove the red drain plug on the lower edge of the condenser.
7 Lay the condenser flat and fill it with water through the filter opening. Now leave the condenser to soak
in water for about 5 minutes, then shower both sides with hot water.
8 Dry the condenser carefully afterwards. Don't forget to put back the red drain plug.
9 Put the condenser back in the dryer. Make sure that its base is lined up in the slots in the condenser
cavity inside the dryer door.
10 Press the condenser carefully into place until you feel and hear a gentle "snap". Put back the fluff filter
and close the coarse filter.

CLEANING THE DRUM

WARNING! Disconnect the appliance
before you clean it.
Use a standard neutral soap detergent to clean the
inner surface of the drum and drum ribs. Dry the
cleaned surfaces with a soft cloth.
CAUTION! Do not use abrasive
materials or steel wool to clean the
drum.
CLEANING THE CONTROL PANEL AND
HOUSING
Use a standard neutral soap detergent to clean the
control panel and housing.
2
6
3
7
Use a moist cloth to clean. Dry the cleaned
surfaces with a soft cloth.
CAUTION! Do not use furniture
cleaning agents or cleaning agents
which can cause corrosion to clean
the appliance.

CLEANING THE AIRFLOW SLOTS

Use a vacuum cleaner to remove the fluff from the
airflow slots.
4
8
11