WORK
Installing the front wheel
3.1
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
Installing the front fender
3.2
–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
–
Change the wheel bearing.
–
Clean and grease the shaft seal rings
Long-life grease (
–
Insert the spacers.
–
Lift the front wheel into the fork, position it, and insert the wheel spindle.
B00304-11
(250 SX‑F ROCZEN REPLICA EU)
–
Align the brake disc guard so that gaps
101075-10
–
Mount and tighten screw
Guideline
Screw, front wheel spindle
–
Activate the hand brake lever multiple times until the brake linings are in contact
with the brake disc.
–
Remove the motorcycle from the lift stand.
–
Pull the front brake and compress the fork powerfully a few times.
B00302-11
The fork legs straighten.
–
Tighten screws
Guideline
Screw, fork stub
–
Ensure that the spacers are mounted in the fender.
–
Position the front fender. Mount and tighten screws
Guideline
Remaining screws, chassis
Info
Make sure the holding lugs engage in the start number plate.
B00307-10
and contact surface
1
p. 13)
A
.
2
M24x1.5
.
3
M8
M6
of the spacers.
A
and
are the same size.
B
45 Nm
(33.2 lbf ft)
15 Nm
(11.1 lbf ft)
.
1
10 Nm (7.4 lbf ft)
6