SETUP
–
Position the controls on the left half of the handlebar.
Info
The figure shows how to route the clutch line and wiring harness.
–
Install the front fender. (
–
Install the front wheel. (
–
Correctly mount the fuel tank breather.
101018-01
–
Mount the handlebar cushion.
–
Install the start number plate. (
C00138-01
–
Mount the footrests with the springs and bolts. Secure the bolts using the washers
and pins.
Pliers for footrest spring (58429083000)
101019-01
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open flames. Charge only in well-
ventilated areas.
–
In the event of skin contact, rinse with large amounts of water. If battery
800035-10
acid gets in the eyes, rinse with water for at least 15 minutes and con-
tact a physician.
–
Fill the battery.
Info
Read the notes in the battery package.
–
Recharge the battery. (
–
Install the battery. (
–
Unpack and mount the KTM PowerParts included in the delivery (optional).
Info
Read the accompanying KTM PowerParts installation instructions.
–
Apply the label included in the delivery (optional).
–
Refuel. (
–
Position all controls in their exact positions on the handlebar. Tighten all screws.
–
Print out the current PDI form found on KTM DEALER.NET and perform the delivery
inspection.
p. 6)
p. 6)
p. 7)
p. 8)
p. 7)
p. 9)
5