Table of Contents
Advertisement
Available languages
Available languages
Installation
B
STEP 5 Powering your washer
24 English
WA8700J_WA22J8700GP-03520L-02_SG_EN.indd 24
3. If the washer is level, the pulsator (A) is
positioned at the center of the water as
shown in the figure.
If not, level your washer by turning
the front leveling feet clockwise or
counterclockwise as necessary.
NOTE
Turn the front leveling feet clockwise (B) to
lower the washer, and counterclockwise (C)
to raise the washer.
C
Plug the power cord into a 3-prong, well
grounded 220-240 volt 50 Hz approved
electrical outlet protected by a fuse or
comparable circuit breaker.
Your washer is grounded through the third
prong of the power cord when plugged into
a three-prong grounded electrical outlet.
Test run
Make sure that you install your washer
correctly by running the Rinse+Spin after
the installation is complete.
2015/7/27 16:55:38
Advertisement
Table of Contents
