Hotpoint Ariston TQ 751 K GH/HA Operating Instructions Manual page 14

4. Once this procedure is finished, replace the old rating sticker with
GB
one indicating the new type of gas used. Sticker are available from
any of our Service Centres.
• Adjusting the burners' primary air
Does not require adjusting.
• Setting the burners to minimum
1. Turn the tap to the low flame position;
2. Remove the knob and adjust the adjustment screw, which is
positioned in or next to the tap pin, until the flame is small but steady.
3. Having adjusted the flame to the required low setting, while the burner
is alight, quickly change the position of the knob from minimum to
maximum and vice versa several times, checking that the flame does
not go out.
4. Some appliances have a safety device (thermocouple) fitted. If the
device fails to work when the burners are set to the low flame setting,
increase this low flame setting using the adjusting screw.
5. Once the adjustment has been made, replace the seals on the by-
passes using sealing wax or a similar substance.
! If the appliance is connected to liquid gas, the regulation screw must
be fastened as tightly as possible.
! Once this procedure is finished, replace the old rating sticker with one
indicating the new type of gas used. Stickers are available from any of
our Service Centres.
! Should the gas pressure used be different (or vary slightly) from the
recommended pressure, a suitable pressure regulator must be fitted
to the inlet pipe (in order to comply with current national regulations).
DATA PLATE
Electrical
see data plate
connections
This appliance conforms to the following
European Economic Community directives:
- 2006/95/EEC dated 12/12/06 (Low
Voltage) and subsequent amendments
- 2004/108/EEC dated 15/12/04
(Electromagnetic Compatibility) and
subsequent amendments
- 93/68/EEC dated 22/07/93 and
subsequent amendments.
- 2009/142/EEC dated 30/11/09 (Gas) and
subsequent amendments.
- 2012/19/EC and subsequent
amendments.
14