Table of Contents
Advertisement
Do not connect the power cord or try to operate the treadmill in the folded position.
5.
Apply a few drops of the lubricant to the inner surface of the belt for the entire width of the belt. A very thin layer of
silicone lubricant on the entire deck below the belt is desired.
NOTICE: Always use a 100% silicone lubricant. Do not use a degreaser like WD-40
performance. We can recommend that you use the following:
• 100% pure silicone, available at most hardware and auto parts stores.
• Lube-N-Walk
Treadmill Lubrication Kit, available from your local distributor or your local specialty fitness dealer.
®
Silicone lubricant is not intended for human consumption. Keep out of reach of children. Store in a safe
place.
6.
Manually rotate the belt 1/2 of the length of the belt and apply lubricant again.
7.
Unfold the machine. Refer to the "Unfolding the Machine" procedure in this manual.
Keep clear of the movement path of the walking deck. Hold onto the walking deck until approximately 2/3 of
the movement down. The walking deck can possibly drop quickly in the last part of the movement.
If you used spray lubricant, wait 5 minutes before turning on power to the machine to allow the aerosol to
dissipate.
8. C onnect the power cord back into the machine and then into the wall outlet.
9.
Turn on the power to the machine with the power switch.
10. S tay to one side of your machine and start the belt at the slowest speed. Let the belt operate for approximately 15
seconds.
Be sure not to touch the walking belt or step on the power cord. Keep bystanders and children away from
the product you are servicing at all times.
11. Switch off your machine.
12. T ake care to clean up any excess lubricant from the deck.
To decrease the possibility of slipping, be sure the deck area is free from grease or oil. Clean off any excess
oil from the machine surfaces.
as this could seriously impact
®
45
Advertisement
Table of Contents
