Mounting the band saw on the swivel arm
If you plan to operate the appliance using the saw
table
, proceed as follows:
♦
Attach the swivel arm
screws
supplied in the corresponding holes
of the appliance housing (see fig . E on the
fold-out page) .
NOTE
►
It is possible that the nuts
tight on delivery . Loosen the nuts
with a 19 mm wrench .
►
Tighten the nut
21a
19 mm wrench if the swivel arm
much play .
WARNING!
►
The band saw may only be used without
the saw table
footing . The workpiece must also be
secured against slipping, for instance on a
workbench .
►
Make sure at all times that the power cord
can not get near the saw blade .
►
If you want to use the appliance with the saw
table, attach the power cable with the cable
A
holder
as shown in the following
diagram:
B
►
For any other use, the cable must be routed
using the cable holders
cable can never get into the sawing/working
area or any other hazardous area .
PMB 1100 B2
using the 3 long wing
are a little too
21a
a little
21a
from time to time with a
has too
if the user has firm, steady
A B
so that the
Making settings
Adjusting the handle
♦
To adjust the handle
screw
♦
Turn the handle
♦
Retighten the wing screw
Using the vice
♦
Turn the handle on the vice
clamp the workpiece .
♦
Turn the handle on the vice
to unclamp the workpiece .
NOTE
►
You can also flip the quick release
in order to adjust the vice
quickly . Fold the quick release
again to fix the vice
the vice handle
Transport restraint
♦
To release the position, pull out the locking
pin
so you can lower the band saw .
♦
Swivel the band saw downwards and push in
the locking pin
port the band saw together with the saw table .
Setting the cutting angle (mitre angle)
♦
Undo the cutting angle adjustment
it anticlockwise .
♦
Set the required cutting angle using the angle
A
provided .
♦
Retighten the cutting angle adjustment
turning it clockwise .
, loosen the wing
on the handle .
to the required position .
.
clockwise to
anticlockwise
setting more
15a
in place . After this, use
to make fine adjustments .
. Now you can easily trans-
GB │ IE │ NI
upwards
15a
back down
by turning
by
│
7
■