Advertisement
• Electronic power control(26)
OFF:Power off MIN:Low power
MAX:Full power
Park-System(16)
For short breaks during vacuuming, for
example to move a small piece of furniture
or a rug, use the Park system to support
the flexible hose and cleaning head.
• Slide the hook attached to the large cleaning
tool into the slot on the rear of the appliance.
Storage(17)
When you have switched off and unplugged
the appliance, press the button (11) to
automatically rewind the cord.
You can move or store your appliance in a
vertical position by sliding the hook on the
large cleaning head into the clip on the
underside of the appliance.
Changing the dust bag
The dustbag needs changing when the
cleaner is set to maximum power and the
cleaner head is off the floor but the
indicator window(18) is completely coloured
red.
Even if the dustbag does not appear to be
full at this stage, it should be changed, as
very fine dust can clog up the pores of the
dust bag.
• Turn off the appliance and unplug it.
• Open the cover by pressing the hook(19)
and lifting it up until it snaps into place.
Your appliance is equipped with either a
paper dust bag (20) o r a fabric dust bag
(25).(depending on model)
• Take hold of the dust bag by the handle
and pull. Remove the bag and throw it
away.
• To refit a new bag push the cardboard
support of a new bag into the bag mount
(21) until it will go no furthe
If your appliance is fitted with a
fabric dust bag
instructions as above.
"bag full"
r.
follow the same
Empty it and replace it(25). Do not wash it.
Note: as the appliance is fitted with a safety
device which checks that the bag is in place
you cannot close the lid if the bag is not
fitted correctly.
Cleaning the motor filter
The motor filter is situated inside the
appliance between the dust bag and the
motor. Each time that you change the air
outlet filter we advise you to remove the
motor filter(22) and to clean it by tapping to
remove the dirt and then replacing it in the
vacuum cleaner.
Changing the air outlet filters
Depending on the model you have chosen
your appliance is equipped with different
types of filters : foam filter or electrostatic
r(24
• To change these filters remove the cover
of the filter compartment(23) situated at
the rear of the appliance.
• The foam filter should be cleaned
regularly by tapping it to remove the dirt.
•
• Wash the washable HEPA filter with water
at least once a year.
What to do if your appliance
does not work?
Check that the appliance is correctly plugged
in and that the electrical socket is working.
What to do when the suction
performance reduces?
• Stop the appliance and unplug it.
• Check that the tubes, flexible hose and
cleaning tool are not blocked.
• Check that the dust bag is not full.Replace
if necessary.
• Check that the air outlet filter is not
blocked. Replace if necessary.
5
.
E
Advertisement
