Advertisement
proper level if you press the "AUTO" button
- Press "CURTAIN" or "CARPET" buttons to
stop the auto mode.
Park-System(16)
For short breaks during vacuuming, for example
to move a small piece of furniture or a rug, use
the Park system to support the cleaning head.
• Slide the hook attached to the large cleaning
tool into the slot on the rear of the appliance.
Carrying and storage(17)
When you have switched off and unplugged the
appliance, press on the button (13) to automati-
cally rewind the cord.
You can move or store your appliance in a vertical
position by sliding the hook on the large cleaning
head into the clip on the underside of the appli-
ance.
Changing the dust bag
The dustbag needs changing when the cleaner is
set to maximum power and the cleaner head is off
the floor but the "bag full" indicator window(18) is
completely coloured red.
Even if the dustbag does not appear to be full at
this stage, it should be changed.
It could be that a great deal of very fine dust has
clogged up the pores of the dust bag.
• Turn off the appliance and unplug it.
• Remove hose from the Vacuum Cleaner.
• Open the cover by pressing the hook(19) and
lifting it up until it snaps into place.
Your appliance is equipped with either a paper
dust bag or a fabric dust bag(20) (depending on
model).
• Take hold of the dust bag by the handle and
pull. Seal bag using the flap(21) on bag card-
board. Remove the bag and throw it away.
• To refit a new bag push the cardboard support
of a new bag into the bag mount(22) until it will
go no further.
If your appliance is fitted with a fabric
dust bag
follow the same instructions as above.
Empty it and replace it(23). Do not wash it.
Note: as the appliance is fitted with a safety
device which checks that the bag is in place you
cannot close the lid if the bag is not fitted correctly.
Cleaning the motor filter
The motor filter is situated inside the appliance
between the dust bag and the motor. Each time
that you change the air outlet filter we advise you
to remove the motor filter(24) and to clean it by
tapping to remove the dirt and then replacing it in
the vacuum cleaner.
Changing the air outlet filters
Depending on the model you have chosen your
appliance is equipped with different types of filters
: electrostatic filter or washable HEPA filter(27).
• To change these filters remove the cover of the
filter compartment(25) situated at the rear of the
appliance, by sliding the lever toward
unlock(26).
(how to remove the cover : After checking the
lever(26) situated at the position "UNLOCK", you
can remove the cover(25) by sliding the cover
toward "OPEN")
• The electrostatic filter should be changed reg-
ularly. (approximately every 6 bag changes)
• The washable HEPA filter with water at least
once a year. (option)
What to do if your appliance
does not work?
Check that the appliance is correctly plugged in
and that the electrical socket is working.
What to do when the suction
performance reduces?
• Stop the appliance and unplug it.
• Check that the tubes, flexible hose and cleaning
tool are not blocked.
• Check that the dust bag is not full. Replace it if
necessary.
• Check that the air outlet filter is not blocked.
Replace it if necessary.
-5-
Advertisement
