Table of Contents
Advertisement
Changing the Hydraulic
Fluid
Service Interval: Every 400 hours/Yearly (whichever
comes first)
1.
Park the machine on a level surface, remove
any attachment, and engage the parking brake.
2.
Raise the loader arms and install the cylinder
lock.
3.
Shut off the engine, remove the key, and allow
the engine to cool.
4.
Open the hood and remove the left side screen.
5.
Remove the hydraulic-tank cap and dipstick
(Figure
65).
Figure 65
1. Hydraulic-tank cap
6.
Place a large drain pain capable of holding 57 L
(15 US gallons) under the drain plug on the front
of the machine
(Figure
Note:
The drain plug is located behind the front
weights, under the sloped plate.
g013121
2. Dipstick
66).
1. Drain plug
7.
Remove the drain plug and allow the oil to drain
into the pan
(Figure
8.
When finished, install and tighten the drain plug.
Note:
Dispose of the used oil at a certified
recycling center.
9.
Fill the hydraulic tank with hydraulic fluid as
specified in
Hydraulic-Fluid Specifications (page
45).
10.
Start the engine and let it run for a few minutes.
11.
Shut off the engine.
12.
Check the hydraulic-fluid level and add fluid to
fill the tank if necessary; refer to
Hydraulic-Fluid Level (page
13.
Install the side screen and close the hood.
47
Figure 66
66).
Checking the
46).
g004213
Advertisement
Table of Contents
