Filling The Rinse Aid Reservoir - Brandt BF3424CW Instruction Manual

Filling The Rinse Aid Reservoir

1
Remove the rinse reservoir cap by
lifting up the handle .
3
Close the cap after all.
Adjusting the rinse aid reservoir
To achieve a better drying performance with limited rinse aid, the dishwasher is
designed to adjust the consumption by user. Follow the below steps.
1. Close the door,
2. Within 60 seconds after the appliance was switched on press the Program button
for more than 5 seconds,
the rinse aid indication blinks as 1Hz frequency.
3. Press the Program button
the setting will change in the following sequence: d3->d4->d5->d1->d2->d3.
The higher the number, the more rinse aid the dishwasher uses.
4. Without operation in 5 seconds or press the Power button to complete the setup
and exit the setting mode
switch on the appliance.
and then press the Delay button to enter the set model,
again to select the proper set according to your using habits,
.
2
Pour the rinse aid into the dispenser,
being careful not to overfill.
12