Table of Contents
Advertisement
Before operation
Notes on cassette tape
Safety tab (accidental erasure prevention tab)
After an important recording has been finished, break the safety tab,
to prevent the recorded contents from being erased or recorded on
accidentally.
Cover with adhesive tape.
To re-record
Notes:
1. 120-minute cassette tape
Since a 120-minute cassette tape is very thin, the tape could
adhere to the pinch roller
or be easily cut. It is recommended that
these tapes not be used with this unit to prevent possible
damage.
Cleaning the head section
Cotton swab
nents
1. Open the cassette holder.
Head
Pinch
roller
pinch roller carefully.
Tape guides
Cleaning the heads and peripheral compo-
|§Demagnetizing the head
For maintaining the best condition of the desk and
the sound quality willbe deteriorated. Insucha case,
vases
for longer service life, always keep the head (record-
| demagnetize the head using a commercially avail-
ing/playback/erase), capstan and pinch roller clean,
| able demagnetizer (head eraser).
To clean them, perform the following:
To store cassette tapes
Do not store the tapes in a place which is subject to direct sunlight,
or near equipment that generates heat.
Keep the cassette tapes
away from any magnetic field.
When there is slack in the tape
In such a case, insert a pencil into the reel hole and wind the reel hub
to remove the slack.
2. Endless tapes
Do not use an endless tape, as this could damage the mechanism
of the unit.
When the recording/playback head is magnetized,
Note:
When cleaning, pay special attention so as not to
apply shock to them.
Beware of condensation
When
water vapor comes
into contact with the surface of cold
material, water drops are produced.
lf condensation occurs, correct operation may not be possible, or
the unit may not function correctly.
This is nota malfunction, however, and the unit should be dried. (To
do this, turn the POWER switch ON and leave the unit as it is for
several hours.)
Be especially careful in the following conditions:
@ When the unit is brought from a cold place to a warm place, and
there is a large temperature difference.
e@ When a heater starts operating.
@ When the unit is brought from an air-conditioned place to a place
of high temperature with high humidity.
@ When there is a large difference between the internal tempera-
ture of the unit and the ambient temperature, or in conditions
where condensation occurs easily.
a
6
KRx-792 (En)
Advertisement
Table of Contents
