Dometic GP-ADV-LiFePO4-100 Quick Start Manual page 2

INTERFACE DESCRIPTION
LED (POWER BUTTON) INDICATORS
LED
Solid light
Blinking light
OFF
VARIOUS POWER MODES
Press button for more than 3 seconds and release. The battery will enter sleep
mode. The LED will blink. Power off mode should only be used for long term
storage or to reset the BMS. Use sleep mode to disable output power of batteries.
Press and hold for 3s and release
Press and hold for 8s and release
Power off Power on
Press and hold for 3s and release
Press and hold for 3s and release
Power on
Sleep
Mode
Press and hold for 8s and release
Power off
Sleep Mode
MOBILE APP
Scan the QR code to download the Go Power! Connect App
for use with the Sun Cycle Advanced Lithium Battery.
®
Battery Mode Definition
Power on mode
Sleep/Reserve mode
Power off mode
Press and hold for 3s and release
or charge battery to above 5Ah
Reserve Power on
Capacity
Press and hold for 8s and release
Power off
Reserve
Capacity
CAN PORT WIRING
RV-C system
(if applicable)
System Connection Cable
Battery End Cap
Terminating Resistor
*cables purchased separately
Part Number
GP-RVC-BCR – ADV LFP TERMINATOR
GP-ADV-BC-400 -ADV LFP INTER-BATT HARNESS, 400MM
GP-RVC-BC -ADV LFP RV-C SYSTEM HARNESS
HOW TO USE
To prevent a surge current, perform a "pre-discharge" as outlined in the
steps below.
Step 1 - Ensure all batteries are in Power Off mode.
Step 2 - Connect batteries following the series or parallel connection diagrams
found at gopowersolar.com/advanced-lithium-wiring. When
stacking multiple batteries, a communication cable is required between
each battery. A Terminating Resistor on the last battery is also required
on each end of the battery bank. (If the installation utilizes a screen, the
terminating resistor is not required on one end.)
Step 3 - Ensure battery pack terminals are correctly installed and connected to
the inverter system.
Step 4 - Press the power button on one of the battery packs for 3 seconds to
wake up all battery packs from Power Off mode. The LED indicator
will turn on.
Batteries are in Power Off mode when unboxed. Press the Power button
NOTE:
for 3 seconds to turn on. If it doesn't turn on, you will need to charge
the battery.
The batteries need to be configured before they can be used. Please see
battery manual for instructions on battery configuration.
Battery Inter-Connect Cable
Function
Ba�ery End Cap Termina�ng Resistor
100Ah Battery Inter-Connect Cable
System Connection Cable