HOMCOM 820-341V70 Instruction Manual page 6

STARTING UNIT AND SELECTING HEAT MODE
UNIT
1.Turn the heater ON by pressing the ON/OFF switch in back.
NOTE: Once power is OFF, heating element will stop working.
Fan will continue for 30 seconds until heater has cooled.
2. Press the Mode button to toggle between the two heating
Modes, to Choose Low/High heat setting, or turn off the heater.
Notice:
When the heat function is used for the first time, a slight smell may be present. This is
normal and should not occur again unless the heater is not used for an extended period
of time.
Notice:
It is normal for the heater to cycle ON or OFF as it maintains the preset temperature. To
prevent the unit from cycling, you need to change the thermostat setting.
SELECTING DESIRED TEMPERATURE
UNIT
15-16-17-···-32 ℃
SETTING POWER OFF TIMER FUNCTION
Notice:
The POWER OFF Timer function will allow for the heater to power OFF after a certain
set time, and can only be set while the heater is in the on mode.
UNIT
1. Press the temperature button to adjust unit to the desired
room temperature.
2. Select temperature from 15°C to 32°C.
NOTE: Once you have chosen the desired temperature, the heater
will remain on until room temperature increases to the set
temperature on the LED display. The heater will cycle ON and OFF to
maintain set room temperature.
1.Turn the heater ON.
2.Press the Timer button.
LED display changes from the "temperature" to the "hours" option for
the timer. Hour options for the timer are 0 to 12 hours (in 1 hour
increments).
3. Continue to press the timer button to change the number of hours
the heater will run before powering itself OFF.
LED Display will ash selected hour increments for a few seconds,
then revert back to the set desired temperature. The heater will power
OFF when the internal heater clock counts down the hour increments
set.
FUNCTION
FUNCTION
FUNCTION
6