Safety Features - HOMCOM 820-341V70 Instruction Manual

23.Pay attention for this heater which have button battery in the remote control.
KEEP OUT OF REACH OF CHILDREN. Swallowing can lead to
23.1
chemical burns, perforation of soft tissue, and death. Severe burns
can occur within 2 hours of ingestion. Seek medical attention
WARNING
immediately.
23.2 Keep batteries out of the reach of children.
23.3 Do not allow children to replace batteries without adult supervision.
23.4 Do not short-circuit batteries.
23.5 Do not heat batteries.
23.6 Remove batteries from equipment if it is not to be used for an extended period of
time unless it is for emergency purposes.
23.7 Always select the correct size and type of battery most suitable for the intended
use. Information provided with the equipment to assist correct battery selection
should be retained for reference.
23.8 Clean the battery contacts and also those of the equipment prior to battery
installation.
23.9 Ensure that the batteries are installed correctly with regard to polarity (+ and –).
23.10 Remove exhausted batteries promptly.
23.11 Do not dismantle batteries.
23.12 Do not dispose of batteries in fire except under conditions of approved and
controlled Incineration.
23.13 Batteries may be disposed of via communal refuse arrangements provided no
local rules to the contrary exist.
Introduction
● Please read this guidance carefully before using your fan heater, so that you can use
it correctly.
● Please keep well with this guidance.

SAFETY FEATURES

Tip-Over Safety Feature
This heater is equipped with a shut-off safety feature. Once the heater is tipped over,
an internal equipment will automatically shut the heater off. Once the heater is
restored to an upright position, the heater will reset. To continue operation, press the
power button on the control panel.
Overheat Safety Feature
This heater is equipped with a overheat safety feature. When the heaters internal
components reach a certain temperature that could cause overheat and possible fire,
the heater will automatically shut off.
● A thermal overload protector is built in to prevent over- heating. When an "overheat"
temperature is reached, the heater will automatically shut off. Operation can resume
only when the user resets the unit.
●To reset the unit, unplug the heater, ensure the power is turned off, and wait 15 to 20
minutes for the unit to cool down.
● Follow INSTRUCTIONS FOR USE to return heater to operating mode.
WARNING:
It is normal for the power cord to feel warm to the touch; however, a loose fit between
the outlet and the plug may cause overheating of the plug. If this occurs, try inserting
the plug into a different outlet. Contact a qualified electrician to inspect the original
outlet for damage.
3