Table of Contents
Advertisement
Use the
and
sensors to increase or reduce fan speed.
Note! Turbo mode is only active for 5 minutes, then fan speed is
reduced automatically to one level down.
To turno the fan, touch
repeatedly until fan speed is reduced to
zero
.
Touch
to turn on / o the lighting.
O -Timer
Use O -Timer to turn o the hood after a specified time. Use O -Timer
to filter the fumes out of the air after cooking. Touch
to activate the
O -Timer at any time. The appliance will automatically turn o after
approximately 15 minutes.
Gesture control
When you plug in your appliance, gesture control is active and
indicator is on. Touch
to turn o the gesture control. Touch
again to reactivate gesture control.
You can use gestures to control the fan speed and lighting. When
gesture control is active, you can also control the appliance using the
touch sensors.Gesture control works correctly when you move your
open hand about 5–10 cm from the surface of the control panel.
Note: To adjust the fan speed you need to move your hand across the
sensors as shown on Figure 4, items 1a and 1b. The area over which to
move your hand is marked on the figures presented below in this
manual.
If activating a certain function (such as turbo speed) requires multiple
hand gestures, reposition your hand for another gesture away from the
control panel to avoid triggering the motion sensors). Hand movements
must not be too fast. Preferably, a single gesture should take about 1
second.
Instruction Manual | 7
Advertisement
Table of Contents
