Table of Contents
Advertisement
IMPORTANT – ONLY USE A 3 AMP FUSE
The use of a 13A fuse can cause internal wiring damage which will not
be covered under the CDA warranty.
Do not mount the electrical isolation switch behind the chimney section.
It is a requirement that you must be able to isolate the extractor from
the mains electrical supply after installation.
Electrical Information
Rated voltage (mains electrical voltage):
Rated input (rated power consumption):
Motor input:
Lamp power:
Troubleshooting
If your extractor is not working
1. Check that the mains electrical supply has not been switched o .
2. Check that the fuse in the spur has not blown.
3. Contact CDA Customer Care.
90W
1 x 5W
230 – 240Vac, 50Hz
95W
Instruction Manual | 13
Advertisement
Table of Contents
