Table of Contents
Advertisement
ь Always mount auxiliary handle 2
and protective guard 3; never
use the tool without them
ь Be sure tool is switched off
when plugging in
DURING USE
ь Inrush currents cause short-time
voltage drops; under
unfavourable power supply
conditions, other equipment
may be affected (if the system
impedance of the power supply
is lower than 0,25 Ohm,
disturbances are unlikely to
occur)
ь Always keep the cord away from
moving parts of the tool; direct
the cord to the rear, away from
the tool
ь If the cord is damaged or cut
through while working, do not
touch the cord, but immediately
disconnect the plug; never use
the tool with a damaged cord
ь Keep hands away from rotating
accessories
ь When grinding metal, sparks are
generated; keep other persons
and combustible material from
work area
ь In case of electrical or
mechanical malfunction,
immediately switch off the tool
and disconnect the plug
ь In case the cutting disc is
blocked, resulting in jerking
forces on the tool, immediately
switch off the tool
ь In case of current interruption or
when the plug is accidentally
pulled out, unlock the on/off
switch immediately and put it in
the OFF-position in order to
prevent uncontrolled restarting
ь Do not apply so much pressure
on the tool that it comes to a
standstill
AFTER USE
ь Before you put down the tool,
switch off the motor and ensure
that all moving parts have come
to a complete standstill
ь After switching off the tool,
never stop the rotation of the
accessory by a lateral force
applied against it.
ь WHEN CONNECTING NEW 3-
PIN PLUG (U.K. ONLY):
ь Do not connect the blue (=
neutral) or brown (= live) wire in
the cord of this tool to the earth
terminal of the plug
ь If for any reason the old plug is
cut off the cord of this tool, it
must be disposed of safely and
not left unattended
GUARANTEE / ENVIRONMENT
ь Always keep tool and cord clean
(especially the ventilation slots)
!
Do not attempt to clean
ventilation slots by inserting pointed
objects through openings
!
Disconnect the plug before
cleaning
ь This "Raider" product is
guaranteed in accordance with
statutory/country-specific
regulations; damage due to
normal wear and tear, overload
or improper handling will be
excluded from the guarantee
ь In case of a complaint, send the
tool undismantled together with
proof of purchase to your dealer
or the nearest "Raider" service
station
SAFETY INSTRUCTIONS
When using electric tools, the following
basic safety precautions should always
be followed to reduce the risk of fire,
electric shock and personal injury.
16
Advertisement
Table of Contents
