Table of Contents
Advertisement
5. Begin with the speedometer installation first;
located in the left side opening in the factory dash.
Cut three pieces of the supplied foam tape, 2"
long. Install foam strips on the top and sides of
each opening about ½" down from the face of the
housing. This foam provides a cushion where the
new VHX cans are installed and forms a tight,
rattle-free fit.
6. Connect one of the CAT5 cables to the new VHX
speed gauge. The speed gauge has two connectors
on the back, only one will be used and it does not
matter which one you connect to; leave the other
connector open.
7. Remove the protective lens tape and insert the VHX speedometer into the left side of the factory
housing. You will need to fold the CAT5 cable and route it through the opening where the original
indicator lights were mounted in order to get the VHX bezel to sit flush with the housing. As the
gauge goes in, route the CAT5 cable through the opening in the bottom of the housing, keeping in
mind the cable needs to reach the control box.
Pre-bend cable to side before
installing so unit will sit flush
once inserted into dash
Foam Tape
Leave open
Cable routed through
indicator light opening
Manual # 650318
Advertisement
Table of Contents
