Dakota Digital VHX-69C-CAM Manual page 2

2. Once the original gauge internals have been removed, there are two reflectors (one on each side)
inside the housing that need to be removed for clearance of the new VHX gauges (see photo).
3. Now, remove the light bulbs and indicator light panels. Since these functions are built into the
VHX system, you can rewire the indicator wires to the control box to retain the desired indicators.
Factory illumination
bulb removed
4. You should be left with a bare housing, now you are ready for VHX installation. This is also a
good time to clean the original housing to remove any dust/dirt before installation of your new
gauges.
Factory indicator
lights removed
Manual # 650318