Dakota Digital VHX-69C-CAM Manual page 4

8. Using the two provided 10-32 x 1.5" screws and nylon shoulder washers, secure the
speedometer assembly to the housing. Start the screws into the back of the factory housing and
into the pull-block on the back of the gauge assembly. Tighten with a 1/8" Allen wrench.
9. To install the tachometer, repeat the steps above, making sure to use the shorter screws and
plastic washers. The tachometer uses two 10-32 x 1" screws and two flat nylon washers to
secure the gauge.
Foam tape
WRONG!!!!
Cable will get
pinched by the
pull block
Bezel flush with housing
once fully seated in housing
and cable properly routed
Pre-bend cable to side before
installing so unit will sit flush
once inserted into dash
Manual # 650318