Table of Contents
Advertisement
9. RADAR
1. From the [Home] screen, tap [Settings] => [Radar] => [General]. The menu op-
tions appear in the right-hand side of the screen.
2. Tap the color indication at [Day Background Color], then tap the background color
to use.
3. Tap the color indication at [Night Background Color], then tap the background col-
or to use.
4. Tap the [x] at the top-right corner of the menu to close the menu.
9.15
Bearing Scale Reference Setup
The bearing scale appears at the outer edge of the range rings and shows the bearing
in relation to your own bearing. The scale can be referenced to True North (True) or
relative to your own vessel (Relative).
1. From the [Home] screen, tap [Settings] => [Radar] => [General]. The menu op-
tions appear in the right-hand side of the screen.
2. Tap the indication at [Bearing Scale Mode], then tap the reference to use.
3. Tap the [x] at the top-right corner of the menu to close the menu.
The manner in which the scale is shown on-screen depends on the combination with
the display orientation.
Where display orientation is set to Head Up
[True]: The heading line always shown pointing to the top of the screen and the scale
moves in relation to your heading.
[Relative]: 0 degrees bearing is always shown at the top of the screen.
Where display orientation is set to North Up
[True]: 0 degrees bearing is always shown at the top of the screen.
[Relative]: The scale moves in relation to your vessel's movements.
9.16
Radar [Initial Setup] Menu
1. From the [Home] screen, tap [Settings] => [Radar] => [Initial Setup]. The menu op-
tions appear in the right-hand side of the screen.
2. Select the item you want to change and set as required, referring to the list below.
• [Tune Initialize]: Select whether or not to use the [Tune Initialize] feature.
• [Random Pulse]: Set to [ON] if the radar shows interference from other radars
or other equipment.
• [On Time]: Shows the total time the radar is powered.
• [Tx Time]: Shows the total transmission time for the radar.
• [Sector Suppression]: Enable or disable the sector suppression feature. Use
this feature stops transmission in a preset arc. Normally this setting is done at
installation and does not require adjustment.
9-6
Advertisement
Table of Contents
