Troubleshooting - Pelgrim PVD25102N Instructions For Use Manual

TROUBLESHOOTING

Problem:
Appliance is connected
to the power mains but
it does not work.
Cooling system
operates continuously
for a long period of
time:
Build-up of ice or frost
in the freezer interior
may be a result of the
following:
Indicator D flashes:
Door is difficult to open:
LED lighting does not
work:
24
Cause or remedy
• Make sure there is voltage in the power outlet and
that the appliance is switched on.
• Too high ambient temperature.
• Door opened too frequently or too long.
• Door not closed correctly (possible impurities on
the seal, misaligned door, damaged seal etc.).
• Too much fresh food inserted at once.
• Insufficient compressor and condenser unit
cooling. Check for sufficient air circulation behind
the appliance and clean the condenser unit.
• The freezer compartment has not been defrosted
periodically. Defrost the freezer compartment to
remove the ice.
• Door not properly closed.
• The door does not seal properly (the seal is dirty,
the door is misaligned or the seal is damaged,
etc.).
• Door opened too frequently or too long.
• Door not closed correctly (possible impurities on
the seal, misaligned door, damaged seal etc.).
• An extended power failure.
• Too much fresh food inserted at once.
• If you are trying to open the freezer door after just
having closed it, this could be difficult to do. As
you open the door, some cool air escapes from
the appliance and it is replaced by warm air from
the environment. When this air is cooled, negative
pressure is generated which results in problems as
you try to open the door. After a few minutes, the
condition is normalized and the door can be easily
opened again.
• If LED lighting does not work, call a service
technician.
• Do not attempt a repair of the LED lighting
yourself, as there is danger of contact with high
voltage!