Installing Wire Spool And Adjusting Hub Tension; Changing Input Voltage - Craftsman 117.205710 Operator's Manual

2-9. Installing Wire Spool And Adjusting Hub Tension

Tools Needed:

2-10. Changing Input Voltage

2
3
Tools Needed:
3/8, 7/16 in
OM-194 199 Page 9
Use compression spring with
8 in (200 mm) spools.
15/16 in
When a slight force is needed
to turn spool, tension is set.
Y Turn Off unit, and disconnect
Unit was shipped from factory set
for 230 volts.
1
2
3
Disconnect 230 volt lead and fan
motor lead from rear of S1. Leave
fan motor lead connected to 230
volt lead.
4
Remove cable tie, and slide short
piece of sleeving off 200 volt lead,
and slide sleeving over end of 230
volt and fan motor leads. Fold
1
sleeving over and secure in place.
Connect 200 volt lead to S1 where
230 volt lead was removed.
Reinstall wrapper.
4
ST-072573-B
input power.
Transformer T1
Rear Of Power Switch S1
Lead Marked 230 Volt And
Fan Motor Lead
Lead Marked 200 Volt
ST-801 580-A