Advertisement
2.
Install the mast to the mast-support mount as
shown in
Figure
4.
3.
Install the upper part of the mast to the machine
fork as shown in
Figure
Figure 4
1. Bolt (3/8 x 3-1/2 inches)
2. Flat washer
3. Spacer
4. Locknut (3/8 inch)
5. Curved washer
6. Bushing
4.
7. Mast
8. Locknut (1/2 inch)
9. Thrust washer
10. Installed mast-support
mount
11. Carriage bolt (1/2 x 2-1/2
inches)
4
Installing the Hydraulics
Parts needed for this procedure:
1
Hydraulic hose (65 cm or 25-1/2 inches)
1
Hydraulic hose (48 cm or 19 inches)
1
Long hydraulic tube (mid-port)
1
Short hydraulic tube (mid-port)
1
Hydraulic tube (no port)
1
Hydraulic hose (90° elbow fitting)
1
Long 90° elbow fitting
1
Short 90° elbow fitting
2
Straight fitting
2
Carriage bolt (5/16 x 3/4 inch)
1
Control manifold
1
Valve bracket
3
Bolt (1/4 x 5/8 inch)
g439863
2
Nut (5/16 inch)
Procedure
WARNING
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury. Fluid injected
into the skin must be surgically removed
within a few hours by a doctor familiar with
this form of injury; otherwise, gangrene may
result.
• Ensure that all hydraulic-fluid hoses
and lines are in good condition and all
hydraulic connections and fittings are tight
before applying pressure to the hydraulic
system.
• Keep your body and hands away from
pinhole leaks or nozzles that eject
high-pressure hydraulic fluid.
• Use cardboard or paper to find hydraulic
leaks; never use your hands.
1.
Ensure the stop pin is in the transport and
maintenance position holding the tool up.
2.
Move the valve control levers forward and
reverse to release internal pressure in the
hydraulic hoses and tubes.
5
Advertisement
