Advertisement
7.
Remove the jumper from the machine wire
harness connector that hangs near the forward
joint of the standing platform
Figure 22
1. Machine wire harness
2. Jumper
(Figure
22).
g411719
3. Chassis plate
8.
Connect the proximity switch to the machine
wire harness connector as shown in
1. Machine wire harness
9.
Check the function of the switch; repeat this step
until the switch functions properly:
•
Start the machine, turn off the laser kit,
engage the parking brake, and step off the
operator platform.
•
If the operator presence switch does not
cause machine to turn off when you leave
the platform, shut off the machine and adjust
the proximity switch assembly position on
the chassis plate to move it closer to the
activator bracket.
10.
Install the oil cooler shroud
15
Figure
Figure 23
2. Proximity switch connector
(Figure
18).
23.
g411671
Advertisement
