Restore Factory Settings - Moen ET900 Owner's Manual

RESTORE FACTORY SETTINGS

To restore the product to the original factory settings, pull the plug from the wall, wait
1 minute and then reconnect the plug. The Water Temp, Seat Temp, Dryer Temp, Spray
Strength, and Nozzle Position will restore to the original Middle level settings.
MAINTENANCE OF PRODUCT
SURFACE AND CERAMICS
Wipe dust or stains with a soft wet cloth.
A wet soft brush, cloth or sponge may be used to clean
the cereamic area.
DO NOT use abrasive cleaning solutions such as alcohol,
bleach, paint thinner, cresol, benzene, gasoline, etc.
MAINTENANCE OF
THE NOZZLE
When powered on and not seated, press the "Nozzle
Clean" button on the remote controller and the washer
will automatically extend. You may gently hold the steel
pipe with one hand and pull out the front end of the noz-
zle outward with the other hand. If there is dirt in the
nozzle orifice, please clean it with a toothbrush. After
cleaning, insert the front end of the nozzle into the steel
pipe. CAUTION: DO NOT HANDLE NOZZLE WITH FORCE.
When the nozzle is clogged, it is recommended to
replace with a brand new one.
DO NOT spray water or detergents on the toilet,
remote control, or on the power cord. Doing so
During the winter season, the water inside
may freeze after long period of storage and
Nozzle
non-usage. Please take measurers to prevent.
Boquilla
NOZZLE
Buse
Before connecting the product to the water
supply and electrical outlet, allow time to
defrost for up to 30 minutes in a warm indoor
In case of extreme cold/freezing/nozzle stuck
in place, wrap the water input line with a warm
towel. Never pour hot water or use a hot dryer
MAINTENANCE &
CLEANING
Regular maintenance is required to
ensure proper performance.
TURN OFF POWER AND WATER
before doing maintenance.
may cause electric shock or fire.
MAINTENANCE DURING
THE WINTER SEASON:
environment.
directly on the toilet.
QSG00036 - 11/02