Moen ET900 Owner's Manual page 10

EXPLANATION OF TOILET FUNCTIONS:
FUNCTION:
AUTO FLUSH
UV ACTIVATION
DRYER
SOFT CLOSING SEAT/LID
PRE-FILTER
MEMORY MODE
KICK FLUSH
KICK CONTROLLED SEAT/LID
LIGHT SENSOR
PRESENCE SENSOR OPERATION
* If the seat time is longer than 5 seconds and there is no flushing after cleansing cycle while seated, it will flush 6 seconds after leaving the seat.
Operates automatically when leaving the seat. The cleaning nozzle will move back to home position, and the UV function will be activated after 10 seconds and remain working for 3 minutes.
The light of the adjustable dial becomes purple. Once seated, the UV function will stop and the dial indicator will go out.
*When the nozzle UV function is running, press the "Stop" button on the remote controller or short press the knob of the product to immediately stop the function.
Press the button to start drying. Press the button again to adjust the speed of air. There are 3 settings: low, medium and high.(This function is limited to ET1100 ET1300 ET2200).
Press stop button to stop drying function. The function of warm air dryer automatically stops in 4 minutes. After cleaning, please use toilet paper to gently wipe off water droplets.
The product has a damping function to make the seat/cover rise and fall smoothly.
Equipped with dedicated carbon, pre-filter and steel mesh filter to purify the water supply to ensure a hygienic cleaning for users.
After power failure, water temperature, water pressure, seat temperature, and wand position are all restored to mid-point setting.
Night light is turned on by default after power failure.
Tap the "Kick Button" with your foot for easy, manual flushing. When seated, tap the "Kick Button" to start an automatic posterior wash cycle. The cycle will run posterior wash for 1.5 minutes,
followed by 4 minutes of drying followed by a flush. During flushing, the wash operations cannot be used. Do not use excessive force to operate the button.
Tap the "Kick Button" with your foot to raise your toilet seat/lid. Tap the kick button once and the lid will open. Tap the kick button twice and the seat will rise.
Tap the kick button three times and the seat and lid will close and the toilet flushes. This function is only available on ET2200 models.
Operating based on the brightness of the environment. The light will be activated based on the brightness of the environment to turn on and off.
The light will be switched off automatically once the environment becomes bright. The light will be switched on automatically once the environment becomes dark.
To turn off: When not seated, press the "Nozzle Clean" and "H/C Massage" buttons on the remote and control for 3 seconds.
A single beep will sound, indicating that the sensor function has turned off. *Repeat steps to turn sensor function back on.
When the product cannot detect a user, the toilet seat and cover will close automatically.
EXPLANATION
Once the user stands up the toilet will automatically flush.
*Ultraviolet lamp device is installed on smart toilet.
This function is only available on ET2200 models.
From about 3 feet from the product, the toilet seat will open automatically.
This function is only available on ET2200 models.