Front Runner KRTT950T Manual

Toyota tundra 2007 2013 - bed rack load bar kit

Download this manual

READ ME FIRST:

Thank you for purchasing a Front Runner Slimline II Load Bed Rack or Load Bar Kit.

Your Kit will contain the following items:

1.) A Slimline II Tray or Load Bar set

2.) Universal Load Bed Legs

3.) Bed Rail Nut Kit

This document will help you fit the Slimeline II Tray or Load Bars to your specific vehicle. If you are mounting

a Slimline II Tray, Please continue with Section 1. If you are fitting Load Bars, please refer to Section 2.

installation of slimline ii tray

Note: When assembling the Legs, discard the Fittings Instructions received with the Legs (Document

LASS026) and assemble the Legs as per Assembly Instructions received with your Nut Kit (RRAC901). Not

all the components received with the Legs will be used as they will be replaced by the Nut Kit.

If your Slimline II Tray is not already assembled, assemble it as per the Slimline II Tray Universal

Assembly Instruction (Document RRSTUNI).

(

)

Remove End Cap and Slide two

Leg Assemblies into each Rail

REV_A00

Toyota TUNDRA

2007 2013

BED RACK LOAD BAR KIT

KRTT950T / KRTT951T

INSTALL TIME: 15 mins

Page 1 BED RACK LOAD BAR KIT KRTT950T / KRTT951T READ ME FIRST: Thank you for purchasing a Front Runner Slimline II Load Bed Rack or Load Bar Kit. Your Kit will contain the following items: 1.) A Slimline II Tray or Load Bar set 2.) Universal Load Bed Legs...
Page 2 installation of slimline ii tray cont... Adjust the two leg assemblies either side of the Midpoint of the factory rails so that they are 884 mm apart - outside to outside as shown below. With your Rack in the upside down position ( Product Sticker should be upside down ) and working with the second Slat in, both front and rear, slide two M8 x 25 Hex Bolts supplied with the Universal Load Bed Legs into...
Page 3 INSTALL TIME: 15 mins installation OF LOAD BARS Note: When assembling the Legs, discard the Fittings Instructions received with the Legs (Document LASS026) and assemble the Legs as per Assembly Instructions received with your Nut Kit (RRAC901). Not all the components received with the Legs will be used as they will be replaced by the Nut Kit. Remove End Cap and Slide two Leg Assemblies into each Rail Slide two M8 x 25 Hex Bolts supplied with the Universal Load...

Krtt951t