Advertisement
installation OF LOAD BARS
Note: When assembling the Legs, discard the Fittings Instructions received with the Legs (Document
LASS026) and assemble the Legs as per Assembly Instructions received with your Nut Kit (RRAC901). Not
all the components received with the Legs will be used as they will be replaced by the Nut Kit.
(
)
A
Remove End Cap and Slide two
Leg Assemblies into each Rail
(
)
Slide two M8 x 25 Hex Bolts supplied with the Universal Load
B
Bed Legs into each end of the Load Bars using the machined
slots as shown.
(
)
Position the Load Bay Legs as required and secure in position. Turn the Load Bars over so that the Bolts
C
inserted in Step 2A are facing down. Lower the Load Bars onto the Legs, lining up the bolts in the Load
Bars with the holes in the Legs. You may need to adjust the position of the Bolts.
Place M8 Flat Washers and M8 Nyloc Nuts onto the Bolts securing the Load Bars to the Legs and hand
tighten. Center the Load Bars Left to Right. Apply weight/downward pressure to the Load Bars so that
they are sitting flush onto the Legs and fasten the M8 Nyloc Nuts securing the Rack to the Legs.
Congratulations, you have completed your installation. Take a step back and admire your work. Good Job!
REV_A00
3
INSTALL TIME: 15 mins
Advertisement
