Advertisement
installation of slimline ii tray cont...
Adjust the two leg assemblies either side of the Midpoint of the factory rails so that they are 884 mm
(
)
B
apart - outside to outside as shown below.
(
)
With your Rack in the upside down position ( Product
C
Sticker should be upside down ) and working with the
second Slat in, both front and rear, slide two M8 x 25 Hex
Bolts supplied with the Universal Load Bed Legs into
each end of the Slat using the machined Slots as shown.
(
)
Grab your friend and with one of you on each side of the Rack, flip it end over end so that the bolts are
D
facing down. Approach the vehicle from the rear lifting the Rack above the Legs. Slowly lower the Rack
lining up the bolts in the Rack with the holes in the Legs. You may need to adjust the position of the Legs.
Position the Rack front to back and fasten the bolts securing the Legs to the Tracks.
Place M8 Flat Washers and M8 Nyloc Nuts onto the Bolts securing the Rack to the Legs and hand tighten.
Center the Rack Left to Right. Apply weight/downward pressure to the Rack so that the Slats are sitting
flush onto the Legs and fasten the M8 Nyloc Nuts securing the Rack to the Legs.
Congratulations, you have completed your installation. Take a step back and admire your work. Good Job!
REV_A00
2
Advertisement
