Checking The Bulbs And Bulb Sockets; Checking The Fuses - Yamaha WR450F 2021 Owner's Service Manual

EAM30357
CHECKING THE BULBS AND BULB
SOCKETS
1. Remove:
• Bulb
ECA25930
NOTICE
Be sure to hold the socket firmly when re-
moving the bulb. Never pull the lead, other-
wise it may be pulled out of the terminal in
the coupler.
2. Check:
• Bulb (for continuity)
(with the digital circuit tester)
No continuity  Replace.
Digital circuit tester (CD732)
90890-03243
Model 88 Multimeter with tachom-
eter
YU-A1927
TIP
Before checking for continuity, set the digital cir-
cuit tester to "" range.
3. Check:
• Bulb socket (for continuity)
(with the digital circuit tester)
No continuity  Replace.
Digital circuit tester (CD732)
90890-03243
Model 88 Multimeter with tachom-
eter
YU-A1927
TIP
Check each bulb socket for continuity in the
same manner as described in the bulb section;
however, note the following.
a. Install a good bulb into the bulb socket.
b. Connect the digital circuit tester probes to
the respective leads of the bulb socket.
c. Check the bulb socket for continuity. If any
of the readings indicate no continuity, re-
place the bulb socket.
EAM30290

CHECKING THE FUSES

The following procedure applies to all of the fus-
es.
1. Remove:
• Seat
Refer to "GENERAL CHASSIS" on page 4-1.
ELECTRICAL COMPONENTS
2. Check:
• Main fuse "1"
• Radiator fan motor fuse "2"
1
2
a. Connect the digital circuit tester to the fuse
and check the continuity.
TIP
Set the digital circuit tester selector to "  ".
Digital circuit tester (CD732)
90890-03243
Model 88 Multimeter with tachom-
eter
YU-A1927
b. If the digital circuit tester indicates "O.L",
replace the fuse.
3. Replace:
• Fuse
a. Install a new fuse of the correct amperage
rating.
b. Push the start switch to verify if the electri-
cal circuit is operational.
c. If the fuse immediately blows again, check
the electrical circuit.
Fuses
Main
Spare
Radiator fan motor
EWA13310
WARNING
Never use a fuse with an amperage rating
other than that specified. Improvising or us-
ing a fuse with the wrong amperage rating
may cause extensive damage to the electri-
cal system, cause the lighting and ignition
systems to malfunction and could possibly
cause a fire.
4. Install:
• Seat
8-59
Amperage
Q'ty
rating
15 A 1
15 A 1
5 A 1