Checking The Bulbs And Bulb Sockets; Checking The Fuses - Yamaha YZ250FX 2022 Owner's Service Manual

EAM30357
CHECKING THE BULBS AND BULB
SOCKETS
1. Remove:
• Bulb
ECA25930
NOTICE
Be sure to hold the socket firmly when re-
moving the bulb. Never pull the lead, other-
wise it may be pulled out of the terminal in
the coupler.
TIP
Bulbs "a" is used for warning light and can be re-
moved from their respective socket by carefully
pulling them out.
a
2. Check:
• Bulb (for continuity)
(with the digital circuit tester)
No continuity  Replace.
Digital circuit tester (CD732)
90890-03243
Model 88 Multimeter with tachom-
eter
YU-A1927
TIP
Before checking for continuity, set the digital cir-
cuit tester to the "" range.
3. Check:
• Bulb socket (for continuity)
(with the digital circuit tester)
No continuity  Replace.
Digital circuit tester (CD732)
90890-03243
Model 88 Multimeter with tachom-
eter
YU-A1927
TIP
Check each bulb socket for continuity in the
same manner as described in the bulb section;
ELECTRICAL COMPONENTS
however, note the following.
a. Install a good bulb into the bulb socket.
b. Connect the digital circuit tester probes to
the respective leads of the bulb socket.
c. Check the bulb socket for continuity. If any
of the readings indicate no continuity, re-
place the bulb socket.
EAM30290

CHECKING THE FUSES

The following procedure applies to all of the fus-
es.
1. Remove:
• Seat
Refer to "GENERAL CHASSIS" on page 4-1.
2. Check:
• Main fuse "1"
• Radiator fan motor fuse "2"
1
a. Connect the digital circuit tester to the fuse
and check the continuity.
TIP
Set the digital circuit tester selector to "  ".
Digital circuit tester (CD732)
90890-03243
Model 88 Multimeter with tachom-
eter
YU-A1927
b. If the digital circuit tester indicates "O.L",
replace the fuse.
3. Replace:
• Fuse
8-49
2 2 2